Correct Way To Start Tongue And Groove Siding

The tongue section of the board should be at the top with the groove section at the bottom.

Correct way to start tongue and groove siding.

To install tongue and groove paneling vertically begin by nailing 1 by 3 furring strips horizontally either directly to the wall studs on a new wall or over the drywall on a finished wall. Gather your new lumber. In horizontal application start at the bottom and work up with the groove edges facing downwards. Finding your replacement boards can be tricky especially with an older house with siding.

The nail can be started with a normal carpenter s hammer and then made flush with the surface of the groove by means of a nail set. Tongue groove installation tongue and groove siding can be installed horizontally or vertically. If the siding is up to 6 inches wide it can be nailed with one siding nail per bearing but siding any wider should use two nails per bearing. Figure out how much lumber you need.

The next grooved edge will hide the nail holes. Nail up the first panel at a corner of the room with the tongue side facing out. This is part 1 of a 3 part series. Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue.

Start by taking a sharp eye to the entirety of your home s perimeter looking. Start with the bottom row first and work your way up. On the side of the building the roof angle was three pitch so we knew we had to cut our tongue and groove cedar boards at a 15 degree angle. For the best look alternate your seams moving from left to right and then right to left can help with this.

Start with your first piece. Nails should penetrate 1 1 4 inch into solid wood behind the siding. Groove facing the wall tongue facing out. How to replace tongue and groove siding 1.

Nail at an angle directly through the tongue and into your studs. The paneling will be nailed directly to these furring strips. Use the framing gun to add a nail to the tongue of the plank and secure in place. For the next piece you will connect the groove of the new piece into the tongue of the first piece.

Drive the nails through the shoulder of the tongues into the framing at about a 45 degree angle. Both types of paneling come in a variety of. Install planks with the tongue up. Once you start to get into the rhythm of installing your tongue and groove walls you ll find that the process is extremely quick even for relatively large rooms.

One of the cool things about tongue and groove walls is that you can use a technique called blind nailing if you do it properly you won t have any nail heads showing or holes to fill.