Cord Drawn Curtain Tracks Instructions

Then feed cord around and over the top pulley g pass cord back through ovelrap master slide.

Cord drawn curtain tracks instructions.

Measure the rod s length while it is still on the wall. 3 unhook cord from master carrier and allow to drop inside track. How to fit new cord to curtain tracks take measurements. I have fitted a metal white curtain track with cord attachments and runners but finding it very difficult to correctly hang the curtains problem overlaper runner hope you can help pulling my hair out thanks.

Standard drill bits work fine on all aluminum tracks. To drill holes identify where the holes should be positioned and mark the track. Draw the cord until the right hand carrier 1 is as far to the right as possible. If you re removing an old cord you can untie it.

Once you have worked out were your track is going to go. 8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor. Replace sliders at each end. Re attach track onto brackets and re hang curtains.

First you ll want to remove the curtain along with the curtain hooks from the rod and carriers. Holding the cords taut push carrier 2 as far to the left as possible. Curtain track features and how to install. Pass the cord over the central bridge on slave master slide f twist cord to create a loop and hook over centre tab f pass cord over the top of the bottom pulley in opposite end pulley.

Next place the rod face down on a flat surface. Add those two. Hook cord over the lug on carrier 2 to secure it. How to thread cord on curtain rails.

Measure also the distance from the floor to the top of the curtain rod. Then remove master carrier from the track. Remove the curtains from the traverse rods so you can access the cording. Cord on overlap master carrier as original.

Fitting instructions for styletrack track if installing into plaster or wallboard where possible try and pick up a timber stud. Installing your styletrack curtain track. If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket. Tension cord and tie off h.

Remove the curtain rod from the. Most curtain tracks do not have the mounting holes pre drilled. Click here for how to mend it.